About Metal Alloy Titanium Rod For Making 3D Printing Powder :
Purposes: Aviation and ship parts, medical use
Titanium And Titanium Alloy Bars For Powder Production In Additive Manufacturing (GB/T38973-2020)
Permissible size deviation:
Allowable deviation of bar diameter is ±0.1mm.
The allowable deviation of bar length is ±5 mm, a small amount of bar length shorter than the nominal length (10~100) mm is allowed, but not more than 5% of the total number.
Both ends of the bar should be cut flat, cutting Angle should not be greater than 4 mm.
The bending degree of the bar should not be greater than 0.7mm /m.
The surface of bar should be clean, no oxide scale, crack, folding and other defects are allowed. Local defects on the surface of the bar shall be removed and cleaned. Depth shall not exceed allowable diameter deviation.
The surface of the bar is allowed to be less than half of the allowable diameter deviation of individual slight scratches, indentations, pitting and other defects.
Payment & Transportation:
Metal Alloy Titanium Rod For Making 3D Printing Powder Properties
|Other Names||Titanium rod|
|Solubility in water||N/A|
Metal Alloy Titanium Rod For Making 3D Printing Powder Health & Safety Information